The 1 Relay Switching Board is a versatile add-on board, based on our popular 3 Relay Switch Board, that has a single DPDT 5V relay (2 switch functions) and a regulated power supply all on one board. It can be powered from either a 5VAC rectifier tap or 6.3VAC filament tap (as long as the switching ground is floating and not reference to the same ground as the filament center tap, or the filament supply center tap is not connected directly to ground).
The 1 Relay Switching Board can be used to switch any functions via 1 button footswitch and/or panel mounted toggle switch. The board also has terminals to accommodate a chassis-mounted LED. The board has a very small footprint – just 3.125in x 1.25in. Only 1in vertical height required (not including any mounting hardware).
DISCLAIMER: User assumes all risks. Performing these modifications will most likely void the warranty on your amplifier. Working on amps can be deadly if you do not take proper precautions. Read and follow the diagram or instructions very carefully. Basic soldering skills and basic user-supplied tools are required. If you are at all unsure of your ability to perform these modifications STOP and take your amp to a professional to be modified. You can also send your amp to us for modification. Contact us for pricing.
DIFFICULTY LEVEL: ADVANCED [Follow safety guidelines for working with electricity. Advanced soldering skills and knowledge of working with AC/DC circuits. Identify all terminals of electronic components using data sheets. Read resistor color codes and capacitor values, as well as identify PNP, NPN, JFET, MOSFET semiconductor devices. Understand relay and switching logic. Measure and connect high and low voltage AC and DC. Understand advanced working of vacuum tubes. Use all functions of a multimeter. Understand Ohms law and apply to basic and advanced circuits. Work with advanced hand and power tools.]