Passive Effects Loop Kit

Easily install an effects loop in your amp. This bare-bones, passive effects loop includes two shorting/switched jacks of your choice, shielded wire, and instructions. Configures the Send jack as a non-interrupted preamp/slave output. Note: This is an interrupt, series type loop, designed to insert between the tone and driver stage. It contains no electronic components or gain devices. You may need to use a buffering device depending on what type of effects you run in the loop.

DISCLAIMER: User assumes all risks. Performing these modifications will most likely void the warranty on your amplifier. Working on amps can be deadly if you do not take proper precautions. Read and follow the diagram or instructions very carefully. Basic soldering skills and basic user-supplied tools are required. If you are at all unsure of your ability to perform these modifications STOP and take your amp to a professional to be modified. You can also send your amp to us for modification. Contact us for pricing.

DIFFICULTY LEVEL: INTERMEDIATE [Follow safety guidelines for working with electricity. Basic soldering skills and knowledge of working with AC/DC circuits. Identify all terminals of electronic components using data sheets. Read resistor color codes and capacitor values. Measure and connect high and low voltage AC and DC. Understand basic working of vacuum tubes. Use all functions of a multimeter. Understand Ohms law and apply to basic circuits. Work with basic hand and power tools.]

Pricing and Options


10 in stock (can be backordered)


    Be the first to review “Passive Effects Loop Kit”

    Your email address will not be published. Required fields are marked *